There's a set of settings in "Message Settings" that are for Netmail - Crash, Hold, Killsent, and Direct.
I have always left those setting off in Mystic and done the routing in
the echomail nodes setup.
A Crash netmail will be sent directly, usually right away, A Hold netmail
will be packed into the outbound ang held for the node to pick up. A
Killsent netmail will be killed from your local message base after it is
packed in the outbound. A Direct netmail will be packed in the outbound
direct to the node in question rather than being routed by your routing
rules.
I'm not sure if mystic will send directly to unknown nodes (nodes not
listed in your echomail nodes) but a little test should answer that. If
not you may need to add the node to your echomail nodes so Mystic knows
where to send it.
Ttyl :-),
Al
--- MagickaBBS v0.13alpha (Linux/x86_64)
* Origin: The Rusty MailBox - Penticton, BC Canada (21:4/106)