How to Repair Battery for Drone Phantom 4 with Ubrt2300 V4
If you have a drone Phantom 4 with a damaged or dead battery, you might be wondering how to fix it and extend its lifespan. One possible solution is to use a software called Ubrt2300 V4, which can help you reset and calibrate the battery cells. In this
article, we will show you how to use Ubrt2300 V4 and an EV2300 interface board to repair your drone battery.

Ubrt2300 V4
Download File https://shurll.com/2wGQ28



What is Ubrt2300 V4?
Ubrt2300 V4 is a software developed by Robot_Labs that can read and write the data of various battery types, such as Li-ion, Li-polymer, Ni-MH, Ni-Cd, etc. It can also perform functions such as capacity test, discharge test, charge test, cycle test, etc.
Ubrt2300 V4 can work with an EV2300 interface board, which is a USB-based device that connects to the battery management system (BMS) of the battery pack. The EV2300 interface board can communicate with the BMS via SMBus or HDQ protocols.

How to Use Ubrt2300 V4 to Repair Battery for Drone Phantom 4?
To use Ubrt2300 V4 to repair your drone battery, you will need the following items:


A drone Phantom 4 battery that needs repair
An EV2300 interface board
A USB cable
A computer with Ubrt2300 V4 installed
A soldering iron and some wires

Here are the steps to follow:


Open the drone battery case carefully and locate the BMS board. You will see a connector with four pins: GND, BAT+, SDA and SCL. These are the pins that you need to connect to the EV2300 interface board.
Solder four wires to the BMS connector pins. Make sure to note the color and position of each wire.
Connect the other ends of the wires to the corresponding pins on the EV2300 interface board. The pinout is as follows: GND to GND, BAT+ to BAT+, SDA to SDA and SCL to SCL.
Connect the USB cable to the EV2300 interface board and plug it into your computer.
Launch Ubrt2300 V4 on your computer and select the appropriate battery type and model. For drone Phantom 4 battery, you can choose Li-polymer and bq40z307.
Click on "Read" button and wait for the software to read the data from the battery. You will see various parameters such as voltage, current, temperature, capacity, cycle count, etc.
If you want to reset the cycle count or capacity of the battery, you can click on "Write" button and enter the desired values. Be careful not to enter values that are too high or too low, as this may damage the battery or cause safety issues.
If you want to calibrate the battery cells, you can click on "Calibrate" button and follow the instructions on the screen. You will need to fully charge and discharge the battery several times until the software shows that the calibration is complete.
After you finish repairing your battery, you can disconnect the wires from the BMS connector and close the battery case. Make sure to test your battery before using it on your drone.

Conclusion
Ubrt2300 V4 is a useful software that can help you repair your drone Phantom 4 battery by resetting and calibrating its parameters. However, it is not a magic tool that can revive any dead or damaged battery. You should always use caution when working
with batteries and follow the safety precautions. If you are not confident or experienced in repairing batteries, you may want to seek professional help instead.


35727fac0c

--- SoupGate-Win32 v1.05
* Origin: fsxNet Usenet Gateway (21:1/5)