• Atlas lathe questions

    From Michael Terrell@21:1/5 to Mark McPherson on Fri Sep 10 07:27:36 2021
    On Thursday, September 9, 2021 at 9:18:06 PM UTC-4, Mark McPherson wrote:
    replying to Harry Conover, Mark McPherson wrote:
    Harry i had the same problem I took the back tumbler gear off and bored out the center hole and made a bushing . then size the bushing and it work great

    --
    for full context, visit https://www.polytechforum.com/metalworking/atlas-lathe-questions-325388-.htm

    You replied to a 17 year old message. Do you think the person is still around?

    --- SoupGate-Win32 v1.05
    * Origin: fsxNet Usenet Gateway (21:1/5)
  • From Bob La Londe@21:1/5 to Michael Terrell on Wed Sep 22 16:52:56 2021
    On 9/10/2021 7:27 AM, Michael Terrell wrote:
    On Thursday, September 9, 2021 at 9:18:06 PM UTC-4, Mark McPherson wrote:
    replying to Harry Conover, Mark McPherson wrote:
    Harry i had the same problem I took the back tumbler gear off and bored out >> the center hole and made a bushing . then size the bushing and it work great >>
    --
    for full context, visit https://www.polytechforum.com/metalworking/atlas-lathe-questions-325388-.htm

    You replied to a 17 year old message. Do you think the person is still around?



    Preliminary testings shows a new sub $5 relay did the trick. Ordered on
    Ebay shipped from Amazon. Maybe it was a sub $3 relay. LOL.

    --
    This email has been checked for viruses by AVG.
    https://www.avg.com

    --- SoupGate-Win32 v1.05
    * Origin: fsxNet Usenet Gateway (21:1/5)