On 2017-10-23,
garsiaantoniomartinez@gmail.com <
garsiaantoniomartinez@gmail.com> wrote:
hello sir
i have question for you.how to figured out how to use the
LOM to configure it ???,please help me about lom ,how to use lom and
how to figured out how to working.This is my email garsiaantoniomartinez@gmail.com
I'll answer in the newsgroup, as this may be helpful to others
as well.
Use your preferred search engine to look for a document labeled:
816-2090-10.pdf
This covers the use of the LOM in chapter 8 and later.
I don't think that the LOM can be used from a keyboard plugged
into the USB ports on the V120, even if you have a framebuffer (graphics
card) plugged into the single PCI slot. Instead, you need a RS-232
terminal plugged into the RJ-45 connector labeled "LOM A" above the
other one labeled "SERIAL B". You will need a converter cable from the
RJ-45 to the DB-25 (or perhaps DE-9) serial port on a terminal, or on a computer acting as a terminal. If you can find one of the CISCO serial
port cables (RJ-45 to DE-9), this will get you close to what you need. Otherwise, you can find the pinout needed in the manuals. In the manual
which I indicated above, go to page 6-7 to find the pinout of the RJ-45
serial connector from the LOM to a DB-25 RS-232 connector.
Later systems include a RJ-45 connector which acts as a
twisted-pair ethernet connector for the LOM (to keep the LOM separate
from any normal networking on the system, so people will not have as
easy a time of breaking into the system.
Thanks very mach sir
Best of luck,
DoN.
--
Remove oil spill source from e-mail
Email: <
BPdnicholsBP@d-and-d.com> | (KV4PH) Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---
--- SoupGate-Win32 v1.05
* Origin: fsxNet Usenet Gateway (21:1/5)