After I make a Hardfile and try to Add Directory the guide I'm
following shows to enter a device name, volume label and then has a
drop down for path and says Workbench3.1 (the Hardfile i just made)
should be listed. It isn't and even if I point to the dir Workbench
3.1 is in, it won't show there... just the path to the folder.
If I type the Hardfile name in and start I get a 'Not a DOS disk in
unit 0' system request box.
What dumb thing did i do? =) What little thing did i miss?
You need to boot of the install disk for your version of workbench.
Then run hdtoolbox to partition the drive.
Then format it, and then install workbench.
I'm not a regular winuae so can't give detailed instructions.
|Location:||Huddersfield, West Yorkshire, UK|
|Nodes:||8 (1 / 7)|